U-Cut Shaft/Grip Mounting Instructions

U-Cut shafts can be shortened up to 6 inches and require a grip with an approximately 7/8” mounting hole.

Materials:

• Medium grit sandpaper
• Waterproof/marine epoxy with thickener
• Latex or Nitrile gloves

Tools:

• Measuring tape
• Fine cutting saw
• Epoxy mixing supplies

Cutting Directions:

1. Determine your ideal paddle length (click here for Paddle Sizing Guidelines) and deduct your grip height. (Note: Do not include shaft insert length).
2. Cut paddle to length determined above.
3. Remove the rough edge of the cut by lightly sanding with sandpaper.
4. Ensure the grip fits the shaft with a trial fit.
5. For your safety, put on gloves before handling epoxy.
6. Mix epoxy according to manufacturers instructions and thicken to the consistency of cake frosting.
7. Trowel epoxy into the grip hole, ensure that it is applied on all sides.
8. Put grip on the shaft, ensuring that the shaft is inserted completely.
9. Double check the grip to blade orientation. A few select grips available are unidirectional. (ex: Curled Palm, curl faces forward. Thumb Notch, notch faces back. See diagrams.)

10. Remove excess epoxy from around the shaft and grip connection.
11. Allow epoxy to set undisturbed per manufacturers directions.

Please feel free to call Sawyer Paddles & Oars at 541-535-3606 or email us with any questions or concerns.